KP-1型电缆偏心测量控制设备是电线电缆生产上一种关键设备。过去对于透明绝缘材料的电缆偏心检测和校正是靠手电筒照,靠操作者目光观察。对于不透明绝缘材料的电缆,就靠操作者手指捏摸,凭经验来控制。有时把电缆的首端和末端切下一个短环来观察,发现偏心较大时,手动调整挤胶膜来进行控制。这些办法劳动强度高,生产率低,而且误差大。由于 KP-1-type cable eccentricity measurement control equipment is a key equipment in wire and cable production. Over the past for transparent insulating materials, cable eccentricity detection and correction is based on the flashlight according to the operator to observe. For opaque insulation of the cable, the operator by the pinch touch, empirically controlled. Sometimes the first end of the cable and the end cut a short ring to observe and found eccentricity larger, manually squeeze the squeeze film to control. These methods are labor-intensive, low-productivity and error-prone. due to