薄壁筒零件的单件小批量生产,在工厂通常条件下,车削加工往往是最易实现,也往往是经济的,但难度很大,尤其是又细又长的薄壁圆筒件的车削,难度更大,这里介绍两种方法。灌注填料法加工零件图如图1所示,材料为铝合金LF6R,总长度0.6米,除两端头壁厚7毫米,中间0.5米长的壁厚仅0.3毫米,车削加工的难度是很大的。 Thin-walled parts of a single small batch production, the factory under normal conditions, turning is often the most easy to achieve, but also often economical, but difficult, especially thin and long thin-walled cylinder turning, the difficulty Larger, here are two ways. Filling filler method processing parts shown in Figure 1, the material is aluminum alloy LF6R, the total length of 0.6 m, except the two ends of the wall thickness of 7 mm, the middle 0.5 m long wall thickness of only 0.3 mm, turning machining is very difficult of.