【摘 要】
：
In order to enhance the surface properties of P 110 oil casing tube steel and increase its life-time during operation, chromizing coating was fabricated by pack cementation.Scanning electron microscop
【出 处】
：
2012 Postdoctoral Symposium of China on Materials Science &
论文部分内容阅读
In order to enhance the surface properties of P 110 oil casing tube steel and increase its life-time during operation, chromizing coating was fabricated by pack cementation.Scanning electron microscope, X-ray diffraction and energy dispersive spectrometer were used to investigate the surface morphology, cross-sectional microstructure, phase constitutions and element distribution of the coating.Comparative research on corrosion resistance between chromizing coating and 13Cr stainless steel in CO2-saturated simulated oilfield brine was carried out via electrochemical measurements.The results showed that the obtained coating was uniform and compact, mainly consisted of MxCy and doped with minor Cr2N.Chromizing treatment made it possible to create on the working surface of Pll0 steel with enhanced corrosion resistance, and the chromizing coating indicated lower pitting corrosion sensitivity than that of 13 Cr stainless steel.
其他文献
The cutting head cut teeth was under high pressure, the shear force and random wallop at its tunneling work, cut teeth in the cut process under the effect of random load, and accompanied by warming ph
3D four directional braided (SiO2)f/SiO2 composites were prepared by silicasol-infiltration-sintering method.The specimen density was determined to be 1.71 g/cm3 by using the Archimedes principle.The
Scrap leather fibers (SLFs) modified with the active silane containing epoxide groups (GPTMS) was incorporated into poly (lactic acid) (PLA) modified by vinyl trimethoxysilane was prepared for bio-com
In order to investigate the mechanism of clay exited in aggregates on the decreasing of polycarboxylate (PC)s water reduction effect, the dispersal effects of PC on clay and cement were compared, and
Combined with the low temperature material properties accurately obtained by the experimental test and the boiling heat transfer coefficient of specimen immersed in the liquid nitrogen bath acquired b
The microstructure and hardness of conventionally solidified Ni-xSi (x=21.4, 22, 24, 26) alloys were investigated.The solidification microstructures of different Ni-Si alloys were observed by OM and S
To develop high damping metal matrix composites, large grain size Barium titanate (BaTiO3) ceramic was sintered and added into Al powder to fabricate BaTiO3/Al composites through the powder metallurgy
A high-strength Mg-15.3Gd-l.8Ag-0.3Zr (GQ152K, wt.%) was prepared by conventional ingot metallurgy process.The T6-treated alloy exhibits remarkable mechanical properties with ultimate tensile strength
A gas shielded arc welding wire was developed for high strength structure steels in this paper.The deposited metals have not only high strength (up to 1000MPa), but also have low yield ratio (0.76), w
Cu-SAPO-34/cordierite catalysts were prepared via one-step hydrothermal synthesis procedure and their performances to remove NOx from the diesel vehicle exhaust were evaluated.Its morphology, structur