论文部分内容阅读
一般情况下,WIN95在安装时将首先检测硬盘是否有介质问题,若无再行安装,但不幸的是负责该功能的SCAN-DISK并不尽如人意。笔者在日前安装一台兼容机时(Pentium75,富士通1.2MB硬盘,海洋主板,SONY光驱),在将硬盘进行分区、高级格式化后,运行WIN95安装,每次均在准备第一次运行WIN95时死机。反复格式化硬盘再安装,故障现象一致,故怀疑是有病毒存在,于是用光盘启动后再行光盘安装,但是仍然在这一处死机,因而排除了病毒的可能。继续检查原因,发现WIN95在运行CONFIG.SYS时执行到HIMEM.SYS即死机,而跳过CONFIG用SAFB模式运行,却能进入WIN95,所以怀疑内存条有问题或有硬件冲突,但用替换法也排除了这两种可能。那么会是什么问题?试着将该硬盘换于另一计算机中进行WIN95安装,发现仍然死在这一地方,这一下终于明白问题原来
Under normal circumstances, WIN95 will first detect the installation of the hard disk for media problems, if no further installation, but unfortunately is responsible for the function of SCAN-DISK is not satisfactory. I recently installed a compatible machine (Pentium75, Fujitsu 1.2MB hard drive, Ocean Motherboard, SONY optical drive), the hard disk partition, advanced formatting, running WIN95 installation, each time you are ready to run the first time WIN95 Crashed. Repeatedly formatted hard drive and then install the same fault phenomenon, so there is a suspicion of a virus, so after the CD-ROM to start the CD-ROM installation, but still in this one crashes, thus ruled out the possibility of the virus. Continue to check the reasons and found that WIN95 running CONFIG.SYS to HIMEM.SYS that crash, and skip CONFIG run with SAFB mode, but can enter WIN95, so there is suspicion of memory problems or hardware conflicts, but the replacement method Ruled out both possibilities. Then what would be the problem? Try to replace the hard disk in another computer WIN95 installation and found that still die in this place, and this finally understand the original