许多工人同志认为千分表只是用在机床上校正偏心或者装在表架上和平板联合使用,实际上,我们可以利用千分表来做检具代替某些检验规,现在举几个例子供大家参考。图1所示是用样板检验阶梯轴的长度。样板的Β端和工件基准面接触的很少,不易靠稳,同时由于要用眼力现察光隙的大小来判定工件是否合格,也比 Many workers commented that the indicator is only used on the machine to calibrate the eccentric or mounted on the table and plate combination, in fact, we can use the dial indicator to do some inspection rules instead of gauges, to give a few examples Everyone’s reference. Figure 1 shows the length of the ladder shaft tested with a template. Model B side and the workpiece surface contact with the few, not easy to rely on stability, at the same time due to the size of the optical gap to determine whether the workpiece is qualified, than the