Numerical Simulation of Viscous Cavitating Flow Around A Ship Propeller

来源 :中国海洋工程(英文版) | 被引量 : 0次 | 上传用户:yong1123
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
In the present study,cavitation and a ship propeller wake are reported by computed fluid dynamics based on viscous multiphase flow theory.Some recent validation results with a hybrid grid based on unsteady Navier-Stokes (N-S) and bubble dynamics equations are presented to predict velocity,pressure and vapor volume fraction in propeller wake in a uniform inflow.Numerical predictions of sheet cavitation,tip vortex cavitation and hub vortex cavitation are in agreement with the experimental data,same as numerical predictions of longitudinal and transversal evolution of the axial velocity.Blade and shaft rate frequency of propeller is well predicted by the computed results of pressure,and tip vortex is the most important to generate the pressure field within the near wake.The overall results indicate that the present approach is reliable for prediction of cavitation and propeller wake on the condition of uniform inflow.
其他文献
本文通过对预算管理的概述,分析钢结构企业预算管理的现状及改进措施,确保钢结构企业的稳步发展。
提出了一种新的硅精炼工艺生产太阳能级多晶硅,即Si-Al熔体低温凝固精炼硅技术.通过杂质在固相硅和Si-Al熔体中的分离热力学分析研究了采用Si-Al熔体分区凝固精炼硅的可行性.
A series of pure and Y3+-doped TiO2 nanoparticles with high photocatalytic activities were prepared by a sol-gel method using tetra-n-butyl titanate as precurso
Perovskite oxide LaMnO3 was prepared by sol-gel method and the nanosize Au/LaMnO3 catalyst was prepared by deposition- precipitation (DP) method in the paper. C
The effects of Nb on the thermal stability and impact toughness of ultra-high intrinsic coercivity of Nd-Fe-B magnets were investigated. The results showed that
采用XRD、吸氢PCT曲线、吸氢动力学曲线、XPS和粒径分析等测试方法,研究LaNi4.25Al0.75合金的结构和储氢性能;推导LaNi4.2sAl0.75合金的四晶胞结构,分析LaN-25Al0.75合金的结
以氩气为保护气体,用同种合金的焊丝对一种2 mm厚的超轻镁锂合金板进行TIG焊接,研究焊接接头的显微组织和力学性能.结果表明,与母材相比,焊缝区晶粒细小,热影响区晶粒粗大.焊
以Li2CO3,HNO3,Si(OC2H5)4为原材料,采用溶胶-凝胶和高温焙烧法合成Li2SiO3;研究焙烧温度和回流系统对硅酸锂组分和性能的影响;利用TGA/DTA,XRD,SEM和粒径分析等手段对样品进
用电化学方法研究Ti基和Zr基非晶合金及与非晶成分相同的Zr基晶态合金在l mol/LH2SO4和3.5%NaCl 溶液中的腐蚀行为.极化曲线测试结果表明:在H2SO4溶液中,Zr基非晶和晶态合金
研究Al-si-Mg合金的微结构对其疲劳性能的影响.利用透射电子显微镜观察不同条件下Al-si-Mg合金中位错的结构,对同一应力幅下不同循环周次试样的基体(011)面进行位错观察.结果