论文部分内容阅读
武汉汽车齿轮厂于一九七七年九月试制成功100吨卧式摆动辗压机,已完成工艺调试并投入生产。该机主要用于加工汽车后半轴法兰,其特点是将工件除变形和夹紧部分外都放在床身之外,工件杆部长度不受限制。并且采用水平分模和油压夹紧,操作方便。主要参数如下: 辗压力 0～100吨夹紧力 0～100吨辗压工作行程 250毫米夹紧缸行程 200毫米偏摆角 3°摆辗头摆动频率 200次/分摆辗头送进量 0.5～1.5毫米/转主电动机容量 40千瓦油泵电动机容量 30千瓦油压 0～200公斤/厘米～2 该厂汽车半轴法兰成形原采用电镦-1000
Wuhan Automobile Gear Factory successfully trial-produced a 100-ton horizontal oscillating roller in September 1977 and completed the commissioning of its technology and put it into production. The machine is mainly used for processing the rear half axle flange of the automobile, which is characterized in that the workpiece is deformed and the clamping part is placed outside the bed body, and the length of the workpiece bar part is not limited. And the use of horizontal clamping and hydraulic clamping, easy to operate. The main parameters are as follows: Rolling force 0 ~ 100 tons Clamping force 0 ~ 100 tons Rolling work stroke 250 mm Clamping cylinder stroke 200 mm Yaw angle 3 ° Swing roller swing frequency 200 times / minute Roller feed 0.5 ~ 1.5 mm / rev Main motor capacity 40 kilowatts Pump motor capacity 30 kilowatts Oil pressure 0 ~ 200 kg / cm ~ 2 The car axle flange forming the original use of electrical upsetting -1000