论文部分内容阅读
三炼钢厂转炉车间在厂党委和车间总支正确领导下,在实现“两不沾”后,喷枪寿命大幅度提高,2号炉3号上枪寿命已达625次,并在继续使用中,喷枪保持完好。这个厂转炉氧枪在1973年9月份以前一直采用低枪位操作,枪他控制在1.6~1.1米,造渣工艺也不太合理,全程化渣不好,喷溅大,喷头个个沾钢,蚀损严重。1973年9月份以后,采取了以下措施,使喷枪寿命大幅度提高。
Three steel mill converter plant in the factory party committee and plant total support under the correct leadership, to achieve “two non-stick,” a substantial increase in the life of the spray gun, No.3 furnace on the 2nd furnace life has reached 625 times, and continue to use The gun remains intact. The factory oxygen converter launchers in September 1973 has been using low-gun operation, the gun he controlled at 1.6 to 1.1 meters, slagging process is not too reasonable, the entire process of slag is not good, splashing, spray a number of James Steel , Serious damage. After September 1973, the following measures were taken to significantly increase the life of the spray gun.