【摘 要】
：
A spectrophotometer with an LED as the light source for uric acid detection is proposed in this work. The mechanism of uric acid detection is based on energy absorbed by sodium urate, which is a chemical product of uric acid and sodium hydroxide solution.
【机 构】
：
FacultyofElectricalEngineering,UniversitiTeknologiMalaysia,81310JohorBahru,Johor,MalaysiaFacultyofEl
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
A spectrophotometer with an LED as the light source for uric acid detection is proposed in this work. The mechanism of uric acid detection is based on energy absorbed by sodium urate, which is a chemical product of uric acid and sodium hydroxide solution. For the performance validation, comparison between the spectrophotometer with an LED and halogen lamp is carried out. Measurement results suggest that the spectrophotometer system with LED light has better sensitivity than that with halogen light. At a 460 nm wavelength, the sensitivity for the spectrophotometer with an LED is 0.0046 dL/mg, which is 73% higher than that with halogen light that records 0.0012 dL/mg. This enhanced sensitivity is attributed to the higher luminous efficacy of the LED light beam. As a result, a larger amount of flux interacts with the sample, leading to the sensitivity enhancement. The spectrophotometer with an LED is also applied for the detection of uric acid in a real human urine sample. Based on the experimental data at a 460 nm wavelength, the method manages to achieve the sensitivity of 0.0016 dL/mg, accuracy of 96.01%, limit of detection of 4.79 mg/dL, and limit of quantification of 14.52 mg/dL. These findings show that the use of LED as the input light source is promising for the spectrophotometer.
其他文献
洛斯·阿拉莫斯国家实验室正在发展一种探测气体中原子和微粒的新技术，即激光感应击穿光谱学。在开始的实验中，研究者洛雷（T. Loree)等把一束Nd:YAG激光射向气体样品并分析所形成的火花光谱以探测微量杂质。例如，已经实时探测到空气中百万分之十二的氯；这个值相当于照明区中有0.3毫微克的元素。由于光谱分析是在激光脉冲过去几微秒后进行的，这时来自高度激发态的大量背景辐射已经消失，信噪比增大，所以氯的探测用时间分辨术。
比较相同偏置条件下镀减反射膜前后的半导体激光器端面自发辐射谱，测得了端面反射率随波长变化的关系曲线。该方法突破了Kaminow法单一波长测量的限制，同时也避免了Kaminow法在两端面镀膜后所遇到的调制度过小的问题。实验中确定出了低于8×10(-5)的第二镀膜端面反射率。
Unintentionally doped AlGaN thin films are grown on c-plane (0001) sapphire substrate by metal-organic chemical vapor deposition, and low-temperature AlN is deposited onto sapphire substrate used as a buffer layer. AlGaN metal-semiconductor-metal ultravio
由激光器产生的光束可探测出进入压力弯折机两折刀之间的人手。而光束对弯折机的工作却毫无影响,就象置有栅栏时一样。目前，在压力弯折机上，最关心安全问题的企业家使用无形栅栏安全装置。该装置由光路组成，装在折刀前几十厘米处。存在的弊病是，这些装置阻碍了对将制成盒子的钢板进行垂直压折。原来在进行第二次压折时，第一次压折所翻起的边挡住了光束,随即停止了压力机的工作。
电荷耦合器件(CCD)多晶硅交叠区域绝缘介质对成品率和器件可靠性具有重要的影响。将氮化硅和二氧化硅作为CCD多晶硅层间复合绝缘介质, 采用扫描电子显微镜(SEM)和电学测试系统研究了多晶硅层间氮化硅和二氧化硅复合绝缘介质对CCD多晶硅栅间距和多晶硅层间击穿电压的影响。研究结果表明, 多晶硅层间复合绝缘介质中的氮化硅填充了多晶硅热氧化层的微小空隙, 可以明显改善绝缘介质质量。多晶硅层间击穿电压随着氮化硅厚度的增加而增大, 但太厚的氮化硅会导致CCD暗电流明显增大。由于复合绝缘介质质量好, 可以减小CCD多晶
具有红、绿、蓝彩色辐射源的三色半导体电致发光指示器可能成为平面彩色电视屏的一种元件。由于以碳化硅为基础，可以获得任意可见光谱区辐射的发光二极管，因此，SiC在制造这种半导体电致发光指示器方面是有前途的。