规整填料内单相流的LDV实验研究

来源 :中国化学工程学报(英文版) | 被引量 : 0次 | 上传用户:dsgver5r33
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
To date,many models have been developed to calculate the flow field in the structured packing by the computational fluid dynamics (CFD) technique,but little experimental work has been carried out to serve the validation of flow simulation. In this work,the velocity profiles of single-phase flow in structured packing are measured at the Reynolds numbers of 20.0,55.7 and 520.1,using the laser Doppler velocimetry (LDV). The time-averaged and instantaneous velocities of three components are obtained simultaneously. The CFD simulation is also carried out to numerically predict the velocity distribution within the structured packing. Comparison shows that the flow pattern,velocity distribution and turbulent kinetic energy (for turbulent flow) on the horizontal plane predicted by CFD simulation are in good agreement with the LDV measured data. The values of the x-and z-velocity components are quantitatively well predicted over the plane in the center of the packing,but the predicted y-component is significantly smaller than the experimental data. It can be concluded that experimental measurement is important for further improvement of CFD model.
其他文献
The effects of the length of solenoid coil on tube compression in electromagnetic forming were investigated either by theory analysis or through sequential coup
Lead-free piezoelectric ceramics (Na0.5K0.5-xLix)NbO3 (x=0.057-0.066) were synthesized by an ordinary sintering technique. Substituting Li for K can lead to str
A novel waterborne epoxy curing agent was prepared using 3-glycidoxypropyl trimethoxysilane (GPTMS) as a termination agent of adduct,which was synthesized by tr
根据阜南县2011年旱稻种植情况,分析旱稻生产中存在的问题,提出发展建议,以指导该县旱稻生产。
Annealing behaviors of hot-deformed magnesium alloy AZ31 were studied at temperatures from 300 to 673 K by optical and SEM/EBSD metallographic observation. Temp
Single phase crystalline cubic boron nitride (cBN) with high yield was prepared by hydrothermal route at low temperature, using hydrochloric acid (HCl) as the p
Electrochemical measurement, quantum chemical method, and scanning electron microscopy (SEM)were performed to investigate the inhibitive effect of 2,3,5-triphen
Carbon brushes with a resin binder were prepared according to an industrial process and the effects of the molding pressure, grains size and cure temperature on
The polymerization of dimethylaminoethyl methacrylate (DMAEMA) catalyzed by the 1-cyclopentylindenyl lanthanide (Ⅱ) complex (1-C5H9C9H6)2Yb (THF)2 was investig
A ductile fracture criterion is introduced into numerical simulation to predict viscous pressure forming limit of the automotive body aluminum alloy 6k21-T4. Th