沉淀-气浮组合工艺处理低浊高藻水试验研究

来源 :给水排水 | 被引量 : 0次 | 上传用户:xixiangreng
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
针对北方地区地表水夏天高藻冬天低温低浊的水质特点,采用沉淀-气浮组合工艺进行了低浊高藻水净水效果的中试研究。通过试验,首先确定了混凝剂PAFC投加量4.5mg/L、进水流量0.6m~3/h和回流比8%的试验条件。在此试验条件下,沉淀-气浮组合工艺的平均出水浊度为0.75NTU,去除率达95.2%;出水的颗粒数总量4 800个/mL,去除率达95.9%,且对不同粒径区间颗粒数去除效果基本一致;出水COD_(Mn)为3.95mg/L,去除率为41.3%,出水藻类数量270万~900万个/L,去除率达96%;臭味物质2-MIB和GSM的含量均小于6×10~(-6) mg/L,低于国标参考值。试验结果表明,沉淀-气浮组合工艺对浊度、颗粒数、藻类、臭味物质等去除率较高,对CODMn有一定的去除效果,低浊高藻水适合采用沉淀-气浮组合工艺进行处理。 Aiming at the low temperature and low turbidity water quality of surface algae in northern China in summer, the pilot-scale research on the effect of low turbidity algae water purification was carried out by the combination of sedimentation and air floatation. Through the test, the test conditions of coagulant PAFC dosage 4.5mg / L, influent flow rate 0.6m ~ 3 / h and reflux ratio 8% were firstly determined. Under the experimental conditions, the average effluent turbidity of the combined precipitation-air flotation process was 0.75 NTU, the removal rate was 95.2%; the total number of effluent particles was 4 800 / mL and the removal rate was 95.9% The results showed that the removal rates of COD-Mn of effluent were 3.95mg / L, the removal rate was 41.3%, the number of effluent algae was 2.7-9.0 million / L and the removal rate was 96% GSM content of less than 6 × 10 ~ (-6) mg / L, lower than the national standard reference value. The results showed that the combination of precipitation and air flotation had a high removal rate of turbidity, particle number, algae and odor, and had a certain removal effect on CODMn. The low turbidity algae water was suitable for the combination of sedimentation and air flotation deal with.
其他文献
研究了一种用于提高排水管道结构承载力的不锈钢制嵌入式管道内支架,该内支架采用适配块的设计,使其与原管道结构共同受力。通过建立热力学模型,确定了该内支架的设计方法并
传统陶瓷材料因其具有耐高温、耐腐蚀、强度高、硬度大等优点,已成为人们普遍关注的对象.但传统陶瓷的脆性问题一直是阻碍陶瓷材料发展的主要因素之一,而由纳米晶组成的陶瓷
矩阵理论已被广泛应用于树木生长模型中,对于给定的一个可持续发展森林的林分,经过调查分析,可用线性系统表示,并且这个简化的系统可以收敛到一个与原始状态无关的稳定状态.
提出用超声复合电加工方法制作微小结构,并分析微细超声、超声复合电火花、超声复合电解微细加工机理;用微细放电组合技术制作多种截形微细工具电极;完善超声复合电加工试验系统
网络编码可使网络通信的容量达到上界,使网络的利用率得到极大的提高.Cai等基于网络编码给出了窃听信道通信网络(CSWN)模型,将信息安全问题引入到网络编码中.文章借鉴密钥共享