The Mathematical Modelling for Studying the Influence of the Initial Stresses and Relaxation Times o

来源 :应用数学(英文) | 被引量 : 0次 | 上传用户：hujinjinliang

【摘要】

：

The present paper concentrates on the study of reflection and refraction phenomena of waves in pyroelectric and piezo-electric media under initial stresses and

【作者】

：

Fatimah A. Alshaikh

【机构】

：

DepartmentofMathematics

【出处】

：

应用数学(英文)

【发表日期】

：

2012年8期

【关键词】

：

Piezo-Thermoelasticity Quasi Plane Longitudinal WAVES Reflection and REFRACTION

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

The present paper concentrates on the study of reflection and refraction phenomena of waves in pyroelectric and piezo-electric media under initial stresses and two relaxation times influence by apply suitable conditions. The generalized theories of linear

其他文献

以碳化细菌纤维素为模板制备碳化硅纳米线

以碳化细菌纤维素为模板和碳源，通过气相渗硅法制备碳化硅纳米线。x射线衍射和扫描电镜（SEM）研究了碳化硅样品的结构与形貌，结果表明所得碳化硅都是纯立方相结构，并且粒度随温度的

期刊

细菌纤维素碳化硅纳米线气相渗硅法Bacterial cellulose SiC nanowires Infiltration process of r

Symmetry Reduction and Explicit Solutions of the (2 + 1)-Dimensional DLW Equation

Utilizing the Clarkson-Kruskal direct method, the symmetry of the (2 + 1)-dimensional dispersive long wave equation is derived. From which, through solving the

期刊

DISPERSIVELongWaveEQUATIONSYMMETRYReductionEXPLICITSolutionSOLITONExcit

Property S[a,b]: A Direct Approach

In this paper we prove directly that the property S[α,b] , implies[α,b) -compact, and under certain conditions it implies [α,b] -compact.

期刊

COMPACTNESSNUMBER[αb]-compactb)-compactPROPERTYS[αb]Compactness number

对我国合金钢连铸发展的几点建议

<正> 1.国外合金钢连铸概况80年代后期,世界约有低合金钢和合金钢方坯连铸机296台,1023流,约占世界方坯连铸机总数的三分之一;约有低合金钢和合金钢(包括不锈钢)板坯连铸机16

期刊

合金钢连铸

冶炼10MoWVNb钢提高Nb回收率的对策

<正> 1.冶炼含铌钢时铌回收率偏低的原因1991年,我厂曾冶炼了两炉10MoWVNb钢,其铌的回收率均只有60%左右,故使钢中铌的成分居于国家标准下限。这不仅损失了大量昂贵的铌铁合

期刊

含铌钢熔炼回收率

The Probability Distribution of the Elastic Properties of Pure Metals

While there are many published data on the average properties of elasticity for metals, there is little on the expected randomness. This is despite the known ra

期刊

ELASTICITYEngineeringMaterialsCentralLIMITTHEOREMPseudo-IsotropyElasticit

电弧炉泡沫渣发泡性能的研究

通过室热模拟试验影响炉渣发泡的主要因素进行分析，并在此基础上制定工艺参数进行工业试验，熔氧期通过增碳和强化吹氧造泡沫渣，泡沫平均厚度３００ｍｍ，维持时间３０ｍｉｎ，取得缩短冶炼时间３０ｍｉｎ，吨钢降低电

期刊

泡沫潭碱度氧化铁电弧炉炼钢

00Cr17Ni14Mo2不锈钢板的研制

介绍了太钢生产００Ｃｒ１７Ｎｉ１４Ｍｏ２不锈钢板材的生产工艺和提高该钢的热塑性的途径和措施，以及解决大锭开坯裂纹的方法。

期刊

不锈钢钢板超低碳钢研制Ultra-low-Carbon Stainless Steel Plate

Hybrid Synchronization of a Chen Hyper-Chaotic System with Two Simple Linear Feedback Controllers

This paper brings attention on the hybrid synchronization of the Chen hyper-chaotic system by using some simple controllers. We give the sufficient conditions f

期刊

HYBRIDSYNCHRONIZATIONCHENHyper-ChaoticSystemLinearFEEDBACKControlHybrid

On Exact Solutions of Second Order Nonlinear Ordinary Differential Equations

In this paper, a new approach for solving the second order nonlinear ordinary differential equation y’’ + p(x;y)y’ = G(x;y) is considered. The results obtain

期刊

NonlinearOrdinaryDIFFERENTIALEQUATIONPARTIALDIFFERENTIALEQUATIONRICCATID

The Mathematical Modelling for Studying the Influence of the Initial Stresses and Relaxation Times o

与本文相关的学术论文