【摘 要】
：
A new sub-aperture overlapping area fusion algorithm based on wavelet transformation is proposed to retain high-frequency components as much as the measurements in the sub-aperture overlapping areas. The principles of sub-aperture stitching are briefly in
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
A new sub-aperture overlapping area fusion algorithm based on wavelet transformation is proposed to retain high-frequency components as much as the measurements in the sub-aperture overlapping areas. The principles of sub-aperture stitching are briefly introduced, and the fusion algorithm based on wavelet transformation is demonstrated. The results of the experiment indicate that the new algorithm improves the retention of high-frequency measurement components.
其他文献
为研究正交偏振云气溶胶激光雷达（CALIOP）最新Version 4（V4）版产品与Version 3（V3）版产品全球大气气溶胶和云衰减后向散射特征的差异及其对以往研究可能造成的影响，利用2011年1、4、7、10月CALIOP 这两个版本的数据，对20.2 km海拔高度内全球范围云和气溶胶样本点的532 nm总衰减后向散射、1064 nm衰减后向散射、总衰减颜色比进行了概率分布统计,并对两个不同版本相应数据的相对偏差做出统计分析。结果表明，云或气溶胶V4版与V3版散射数据的相对偏差趋于正值，夜间数据的
研究了非量测型移轴组合相机的图像拼接技术,以双拼移轴相机为研究对象,探讨了其虚拟像空间坐标系建立,并以此为基础建立子影像至虚拟影像的变换模型。提出一种基于初值约束的投影矩阵自检校方法,该方法利用移轴相机检校参数,结合子影像变换模型,推导和计算自检校方程,精确解求虚拟影像拼接参数。设计了室内外地面实验以及航飞实验,对提出的方法进行了验证。实验结果表明,利用该方法进行移轴组合相机虚拟影像拼接,精度优于
A single-frequency pulsed erbium-doped fiber (EDF) laser with master-oscillator power-amplifier configuration at 1 533 nm is developed. A short-cavity, erbium-doped phosphate glass fiber laser is utilized as a seeder laser with a linewidth of 5 kHz and po
Entanglement distribution between distant parties is one of the most important and challenging tasks in quantum communication. Distribution of photonic entangled states using optical fiber links is a fundamental building block toward quantum networks. Amo
A novel non-feedback precoder circuit for high-speed parallel optical differential quadrature phase shift keying (DQPSK) modulation is proposed. The alternative control signal is introduced in replacement of the conventional feedback one, which eliminates
本文提出了一种研测面内振动的技术——频闪云纹倍增技术.它可用商品化的低密度云纹栅获得高灵敏度的测量结果.
采用激光诱导TIG电弧焊方法进行了1.5 mm厚6061-T6和5083-O异种铝合金的拼焊试验,系统研究了激光的加入对焊接接头塌陷变化和力学性能的影响规律。结果表明:由于两种铝合金的化学成分和热物理性能的差异,焊接接头会出现不一致的塌陷现象;与电弧焊相比,激光的加入不仅可以有效降低焊接接头的塌陷程度,还会大幅降低焊接接头塌陷深度比的不一致程度;随着激光功率增大,焊接接头塌陷的不一致程度呈减小的趋势,导致接头受力情况发生变化,使接头强度呈先增后减的趋势。
提出了磁场辅助激光沉积类金刚石(DLC)膜技术, 在硅基底附近添加磁力线向基底收拢的磁场, 用以迫使侧向飞行的离子向基底靠拢并参与成膜。由于离子向基底的集中, 使其在膜层中含量大幅上升, 间接地减少了大颗粒的比例, 因此, 与无磁场条件下制备的DLC膜相比, 引入磁场不仅提高了DLC膜的沉积速率, 而且提高了其机械硬度; 更重要的是, 间接地证明了激光对靶材离化的高效性, 为脉冲激光沉积(PLD)结合磁过滤技术提供了可行性的依据。