Investigation on Phase Evolution of the ZnO-B2O3-SiO2 Glass Ceramics

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:xuliangaihui
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
ZnO-B2O3-SiO2-Al2O3-Na2O glass doped with nucleating agent TiO2 was prepared with melting-quenching method and the effect of nucleating agent on the crystallization behavior and phase evolution of this glass was investigated by differential thermal analysis (DTA), X-ray diffraction (XRD), and scanning electron microscopy (SEM). The experimental results show that the glass transition temperature and the ifrst crystallization temperature decrease from 630℃ and 765℃ to 595℃ and 740℃, respectively, with introduction of TiO2 into glass. There is no diffraction peaks in the XRD pattern but it is no longer transparent for the base glass without nucleating agent after heat treatment, which suggests the serious phase separation occurred, and the observation by SEM indicates that the phase separation is developed by nucleation and growth mechanism. However, there are two different crystals ZnAl2O4 and NaAlSiO4 present in the glass containing TiO2 after heat treating at 575℃for 2 h and 740℃ for 6 h, respectively. What is interesting is that NaAlSiO4 disappears as the crystallization time at 740℃ increases from 6 h to 12 h, and more ZnAl2O4 crystal is formed, namely, the further formation of ZnAl2O4 is at cost of NaAlSiO4 with increasing crystallization time. And observation of the morphology of glass ceramics shows great difference with increasing crystallization time. Moreover, the ability of ZnO-B2O3-SiO2-Al2O3-Na2O glass ceramics against attacking of 1M HCl solution is increased by the crystals precipitated in heat treatment process.
其他文献
Intrinsic carrier concentration (ni) is one of the most important physical parameters for understanding the physics of strained Si and Si1-xGex materials as well as for evaluating the electrical properties of Si-based strained devices. Up to now, the repo
A novel design scheme of hot stamping, quenching and partitioning process was conducted in a quenchable boron steel to obtain the nanometric duplex microstructure comprising ultrafine retained austenite and martensite. It is shown that the materials posse
Quenching experiments were performed at different cooling rates under non-directional solidification by differential thermal analysis, and the morphologic variation of primary phase, phase transition temperature and hardness change at the same quenching t
Aiming at overcoming the difficulties in integral forming of thin-walled tubes with complex shapes, a novel forming method by inner and outer pressure through viscous was proposed. In this method, by dividing large deformation of the part into inner and o
A new type of adjustable nozzle with an annulus clearance between the surfaces of a revolved solid and the matched hole was analyzed, which contained matching parts, regulating parts, guiding elements, and sealing part. The general regulating function of
Multi-walled carbon nanotubes (MWCNTs) reinforced hollow glass microspheres (HGMs)/epoxy syntactic foam was fabricated.The effects of ultrasonication on the density,compression strength,and water absorption properties were studied.Better dispersed MWCNTs
Layered cathode materials of high-temperature lithium batteries, LiNi1/3Mn1/3Co1/3O2 are synthesized by a sol-gel method with variation in final sintering temperature for borehole applications. The structure, morphology and high-temperature discharge perf