论文部分内容阅读
在立铣上加工图1平面体上的曲线油槽,一般方法是先划线,然后,靠虎钳反复扳转角度铣出,效率低、质量差、操作复杂。为此,我们革新了一种简易靠模铣夹具,使用效果良好。其结构和安装情况如图2所示。一、结构原理导板2由楔块3、螺钉4固定在铣床垂直导轨1上,其高低位置可以上下调整,螺钉6把靠模板5同导板2连成一体。滑座7夹在虎钳钳口
In the vertical milling process on the plane of Figure 1 curve tank, the general method is to scribe, and then rely on the vice jaw angle pull milling repeatedly, low efficiency, poor quality, complex operation. To this end, we have renovated a simple model milling fixture, with good results. The structure and installation shown in Figure 2. First, the structural principle Guide plate 2 by the wedge 3, 4 screws fixed on the vertical guide rail milling machine 1, the height of the position can be adjusted up and down, screw 6 by template 5 with the guide plate 2 into one. Slider 7 in the vise jaws