如图所示的夹具用于加工手柄的两侧平面,一次可装夹两个工件,加工结果完全符合图纸要求,光洁度可达▽_7,比原来的效率提高十多倍,降低了刀具成本,收到了良好的技术经济效果。现介绍如下:将胎具体1底面定位槽内的两个定位块9放在铣床工作台的丁字槽中,两端用螺栓压紧。胎具体中间的槽与 D 面所成角度要做成图纸要求的角度,并在垂直槽的中心钻一个孔 The fixture shown in the figure is used to process the two sides of the handle. Two workpieces can be clamped at one time. The machining result fully meets the requirements of the drawing. The smoothness can reach ▽ _7, more than ten times the original efficiency, reducing the tool cost, Received a good technical and economic results. Now introduced as follows: The tire positioning the bottom of the positioning of a specific two positioning blocks 9 on the milling table T-slot, both ends of the bolt pressed. The middle of the tire and the D-shaped surface of the angle made by the drawing to make the required angle, and drill a hole in the center of the vertical groove