论文部分内容阅读
一、安裝的技術要求: (一)位置关係:基礎找正和承托座的安裝,應按照下列設計要求的水平和垂直方向位置進行。 1.水平跨距:因為胴體在生產時過熱就會伸長,所以各擋領圈和托輪面的中心間,在安裝時應有一定的距離,以便胴體受熱伸長領圈隨之順移時,能使領圈面和托輪面全部接觸。第三擋領圈因受前後兩平面擋輪抵住,無從向前后穿動之可能,所以必須以第三擋承托基礎中心为原點。計算它和各擋領圈間胴體在生產時的伸長量,亦即各擋領圈向窑頭及窑尾的移動距離,根據計算結果,各擋托輪的水平位置應符合下列要求: (1)第一擋承托的安裝位置,應能滿足胴體向窑頭伸長110公厘的要求; (2)第二擋承托的安裝位置,應能滿足胴體向窖頭伸長50公厘的要求;
First, the installation of technical requirements: (a) the location of the relationship: the foundation to find positive and supporting seat installation, should be in accordance with the following design requirements of the horizontal and vertical position. 1. Horizontal span: Because the carcass will be overheated in the production will be extended, so the retaining collar and the center of the support roller surface, there should be a certain distance in the installation, so that when the carcass is extended by the extension of the collar collapses, Can collar collar and care round face all contact. The third ring collar due to the front and rear two flat wheel stop, there is no possibility to move forward and backward, it must be based on the third block support base as the origin. According to the calculation result, the horizontal position of each gear should meet the following requirements: (1 ) The first retaining bracket should be installed so that the carcass can extend 110 mm to the kiln head. (2) The second retaining bracket should be installed so that the carcass can meet the requirement of extending 50 mm to the pithead.