论文部分内容阅读
图中所示是一种顶料装置,用来顶出模具中的制件。安装在机身工作台的下面。该顶料器是由一组中心橡胶圈及六组外围橡胶圈组成。分别称为中心顶料器及外围顶料器。中心顶料器安装在上、下夹板8、12及下
Shown in the figure is a topping device that ejects the part from the mold. Installed in the fuselage table below. The ejector is composed of a set of central rubber ring and six sets of peripheral rubber ring. Known as the center ejector and peripheral ejector. Center ejectors installed in the upper and lower splints 8, 12 and under