论文部分内容阅读
我厂三车间的角铁下料,原全靠手工锯,劳动强度大,工效低,成本高,为此,老工人孟繁荣等师傅利用废旧零部件制成了角铁任意角度下料夹具,与砂轮切割机配合使用,效果很好,并解决了各种角度(如30°、45°、60°等)的角铁下料。 该夹具结构如图所示。它由上圆盘(转盘)3、下圆盘(固定盘)2、夹持体5等部分所组成。下圆盘上有下型槽,用螺钉与上圆盘联结。上圆盘连同夹持体可以作任意所需角度旋转。将底座1夹持在砂轮切割机的虎钳上,角铁装在夹持体5的槽内,用螺钉6固定,便可使用。
I plant three angle iron cutting workshop, the original whole manual saw, labor-intensive, low efficiency, high cost, to this end, the old workers Meng Fanrong and other masters made use of scrap parts angle iron cutting fixture at any angle, With the use of wheel cutting machine, the effect is very good, and to solve a variety of angles (such as 30 °, 45 °, 60 °, etc.) angle iron feeding. The fixture structure as shown. It is composed of the upper disc (turntable) 3, the lower disc (fixed disc) 2, the holder 5 and other parts. The lower disc has a lower groove, with a screw and the disc connected. The upper disc together with the holder can be rotated at any desired angle. The base 1 is clamped on the vise of the wheel cutting machine. The angle iron is installed in the groove of the holding body 5 and fixed with the screw 6, so as to be used.