连铸连轧和冷装热轧并存环境下的炼钢-连铸生产调度模型与算法

来源 :系统工程理论与实践 | 被引量 : 0次 | 上传用户：reg8c4user

【摘要】

：

针对连铸连轧和冷装热轧并存环境下的炼钢-连铸生产调度问题,建立了基于浇次开浇时间的炉次指派和作业排序模型.在该模型中,通过浇次开浇时间单位提前/拖期成本的惩罚值的控

【作者】

：

李铁克周健孙林

【机构】

：

北京科技大学管理学院

【出处】

：

系统工程理论与实践

【发表日期】

：

2004年期

【关键词】

：

生产调度炼钢-连铸热轧遗传算法

【基金项目】

：

国家自然科学基金;

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

针对连铸连轧和冷装热轧并存环境下的炼钢-连铸生产调度问题,建立了基于浇次开浇时间的炉次指派和作业排序模型.在该模型中,通过浇次开浇时间单位提前/拖期成本的惩罚值的控制可以协调炼钢-连铸和热轧生产环节之间的匹配关系.对所建立的模型,提出了基于遗传算法和线性规划的实用算法,并给出了源于实际生产数据的计算实例.

其他文献

现代企业经济管理模式的规范化探析

企业经济管理模式与企业效益密切相关,通过探索企业经济管理的规范化方法,不仅有助于为企业赢得更大的经济效益,推动企业的可持续发展,而且对现代企业经济管理制度的建立具有

期刊

现代企业经济管理模式规范化

Synthesis of Ni-Zn ferrite and its microstructure and magnetic properties

Nanometer Ni0.5Zn0.5Fe2O4 powders with spinel phase were prepared by the hydrothermal method using purified FeSO4 solution from sodium jarosites slag as materia

期刊

sodium jarositehydrothermal synthesisNi-Zn ferritenanoparticle

Numerical study on maximum rebound ratio in blasting wave propagation along radian direction normal

In the process of 2-D compressional wave propagation in a rock mass with multiple parallel joints along the radian direction normal to the joints, the maximum p

期刊

2-D compressional wavemaximum rebound ratiostiffness of joint

Preparation of spherical cobalt carbonate powder with high tap density

Spherical cobalt carbonate with high tap density, good crystallization and uniform particle size was prepared by controlled chemical crystal method using cobalt

期刊

controlled chemical crystal methodspherical cobalt carbonatetap densitycrysta

Lubrication effectiveness of composite lubricants during P/M electrostatic die wall lubrication and

The lubrication effectiveness of the composite lubricants, 50wt% ethylene bis-stearamide (EBS) wax + 50wt% graphite and 50wt% EBS wax + 50wt% BN, during the pow

期刊

powder metallurgycomposite lubricantelectrostaticdie wall lubricationwarm co

Acid equilibrium during bioleaching of alkaline low-grade sulfide copper ore

This article reports the study on acid equilibrium during bioleaching of alkaline low-grade copper sulfide ore.Adding auxiliary agents 1# (sulfur) and 2# (pyrit

期刊

bioleachingalkaline low-grade copper sulfide oreacid equilibriumprocess miner

TiC-Maraging stainless steel composite: microstructure, mechanical and wear properties

Particulate TiC reinforced 17-4PH and 465 maraging stainless steel matrix composites were processed by conventional powder metallurgy (P/M). TiC-maraging stainl

期刊

TiC-maraging stainless steel compositesagingwearpowder metallurgymicrocracks

天水烟草探索非物质激励模式--助推烟草员工良性发展

在新的历史条件下,烟草员工所面临的生活和工作压力越来越大,挑战越来越多,新情况、新问题层出不穷,新事物、新观念应接不暇,导致各种心理问题随之增加。如何让烟草员工在物

期刊

烟草非物质激励模式探索

Effect of Al content on the phase structure and the hydrogenation characteristic of La(Mg1-xAlx) all

La(Mg1-xAlx) (x=0.2,0.4,0.6,0.8) alloys have been prepared using induction melting followed by annealing. It is found that partial substitution of Mg by Al does

期刊

intermetallic compoundphase structurehydrogenation characteristicX-ray diffra

Microstructure and mechanical properties of hot isostatically pressed cermets with TiN coatings

To increase the adhesion strength between the coating and the substrate, sintered Ti(C,N)-based cermets were selected and deposited with monolayer TiN using a m

期刊

materials surface and interfacecoating adhesionhot isostatic pressingcermets

连铸连轧和冷装热轧并存环境下的炼钢-连铸生产调度模型与算法

其他学术论文