论文部分内容阅读
本试验是用测量光电倍增管输出电压的电子学方法,研究白热光照射带骨鱼块的检骨效果。这些输出电压是在不同的试验条件下漫射光束照射在鱼骨上产生的,其不同的试验条件如下: 1.二种鱼块厚度为6.35亳米和12.70毫米; 2.二种对应的运输机皮带的速度为0.1米/秒和0.2米/秒; 3.从鱼块中挑选出四种不同厚度的鱼骨,即0.254亳米,0.381亳米,0.508亳米,0.635亳米。取其中之一的鱼骨,在三种皮带速度条件下,即0.10米/秒,0.20米/秒,0.40米/秒,重复三次试验; 4.用四种不同波长的光束,即480亳微米,530亳微米,650亳微米和白热光,对四种鱼骨中每一种依次进行试验。
This test is to measure the photomultiplier tube voltage output electron method to study the white hot light irradiation bones flesh of the bone seepage results. These output voltages are generated by diffused light beam irradiation on the fishbone under different test conditions. The different test conditions are as follows: 1. The thickness of the two fish pieces is 6.35 millimeters and 12.70 millimeters. 2. Two kinds of corresponding conveyor belts At speeds of 0.1 m / s and 0.2 m / s; 3. Four fish bones of different thicknesses, 0.254 millimeters, 0.381 millimeters, 0.508 millimeters and 0.635 millimeters, are picked from the fish pieces. Take one of the fish bones and repeat the test three times at three belt speeds, 0.10 m / s, 0.20 m / s and 0.40 m / s. 4. Use four different wavelengths of light, 480 nm , 530 millimicrons, 650 millimicron millimeters and white hot light, each of the four fish bones in turn were tested.