可卸式防尘盖轴承的弹簧圈,历来都是用人工双手往槽内装.由于弹簧圈本身小,又是一个开口的小圆圈,工人稍不注意,弹簧圈就容易变形,同时劳动强度大、效率低,质量不易保证.为此,我车间双革措施小组,本着“学先进、找差距”的精神,采用三结合方式,自行设计和制造了一台压入弹簧圈的气动工具(图1)该工具结构简单,制造容易,操作方便,适合于大批量生产.实践证明:生产效率比原来手工操作提高工效4～5倍,达300 Detachable dust cover bearing spring coil, has always been to the hands with both hands inside the slot. Because the coil itself is small, but also a small circle of openings, the workers a little attention, the coil is easy to deformation, while labor-intensive , Inefficient, difficult to guarantee the quality.Therefore, I workshop double leather measures group, in the spirit of “learning advanced, looking for the gap”, the use of three combinations, to design and manufacture of a pneumatic spring into the pneumatic tools Figure 1) The tool is simple, easy to manufacture, easy to operate, suitable for mass production.Practice has proved that: production efficiency than the original manual to improve work efficiency 4 to 5 times, up to 300