Effect of SiO2 Aerogel-cement Mortar Coating on Strength of Self-Compacting Concrete after Simulated

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:hathaway60000
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
In order to facilitate self-compacting concrete to be better used in tunnel linings that can resist fires, a SiO2 aerogel-cement mortar coating was prepared. Based on the HC curve, a self compacting concrete cube specimens coated and uncoated with SiO2 aerogel-cement mortar (SiO2-ACM) were heated to simulate tunnel fire for 0.5, 1, 1.5, 2, 2.5, 3 and 4 h, respectively.The residual compressive strength was tested after the specimens were cooled to room temperature by natural cooling and water cooling. The results show that, the damages of specimens become more serious as fire time goes on, but the residual strength of specimens coated with SiO2-ACM is always higher than that of uncoated with SiO2-ACM. In addition, the residual strength of specimens cooled by water cooling is lower than that of natural cooling. However, for the specimens coated with SiO2-ACM, the adverse effects of water cooling are lessened. With the increase of fire time, the protective effect of SiO2-ACM is still gradually improved. Finally, a formula was established to predict the residual 150 mm cube compressive strength of specimens protected by SiO2-ACM after a simulated tunnel fire.
其他文献
The heavyweight ultra-high performance concrete (HUHPC) was prepared with barite sand partially replaced by titanium-rich heavy slag sand (THS) at replacement proportion of 0%, 30%, 50%, 70% and 100% in this work. The results show that THS incorporation c
The pre-soaked shale employed as an internal curing agent and CaO employed as expansion agent were incorporated into concrete to investigate their effects on the mechanical properties and autogenous deformation of early-age concrete. We have conducted the
The physical performance of recycled asphalt was used as the main evaluation index to study the optimal range of a self-made rejuvenator. Through the penetration, viscosity and gel permeation chromatography (GPC) tests, the diffusion degree of the rejuven
The electrical conductivity of graphene/cement composite before and after carbonation was tested by a four-electrode method. The General Effective Media equation was adopted to fit the experiment results. EIS (electrochemical impedance spectroscopy) was e
A polarizing microscope, X-ray diffraction (XRD), fourier transform infrared spectrometer (FTIR), scanning electron microscope and energy dispersive spectrometer (SEM-EDS), X-ray photoelectron spectroscopy (XPS), and micro computed tomography (Micro CT) w
Nano-pellet α-Al2O3 was prepared using aluminum nitrate as precursor and urea as fuel by a fast method of solution combustion synthesis. The formation of the nano material was dependent on the molar ratio of fuel/oxidant, calcination temperature, and fore
Aluminum sol, dry gel, and film were prepared by sol-gel and a dipping-withdrawing method. The effect of polyethylene glycol (PEG) on the behavior of aluminum sol, gel, and film was investigated by DLS, rotary viscometer, XRD, IR, EPMA, and light microsco
A quantitative pH measuring method has been used to measure the pH of pure and blended cement mortars. The blended cement mortars incorporating supplementary cementitious materials (SCMs) such as fly ash (FA), ground granulated ballast furnace slag (GGBFS
With the risk of disappearing for the rock paintings considering long-term exposure in Helan Mountain, the freeze-thaw(F-T) cycling experiments were carried out with 12-hour F-T cycling (0, 10, 20, 30, and 40 F-T cycles) under five kinds of confining pres
TiSi2 reinforced boron phenolic composites (TP) and Vitreous silica fabric reinforced TiSi2/boron phenolic composites (VTP) were prepared by compression molding, and their thermal, mechanical, ablation properties were studied. TG results show that thermal