我厂有八台Y631K花键铣,其溜板导轨原设计由操作工用油枪加油,每班需注油4～6次,影响工作。后来改用油绳吸油润滑,节省了工时,且效果良好。改进方法是,在原弹子油嘴外面用501胶粘剂粘上一个小油盒,油嘴里装上吸油毛绳,由操作工人班前添加适量机油,即可保证当班的润滑。 My factory has eight Y631K spline milling, the slide plate guide the original design by the operator with a fuel gun, each class need to oil 4 to 6 times, affecting the work. Later switched to oil rope lubrication oil, save working hours, and the effect is good. The improvement method is, outside the original marbles nozzle with 501 adhesive stick a small oil box, oil nozzle filled with oil absorption rope, the operator by the class to add an appropriate amount of oil, you can ensure on duty lubrication.