Properties of Boron-dopedμc-Ge:H Films Deposited by Hot-wire CVD

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:dellson
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Boron-doped hydrogenated microcrystalline Germanium (μc-Ge:H)fi lms were deposited by hot-wire CVD. H2 diluted GeH4 and B2H6 were used as precursors and the substrate temperature was kept at 300?. The properties of the samples were analyzed by XRD, Raman spectroscopy, Fourier transform infrared spectrometer and Hall Effect measurement with Van der Pauw method. It is found that thefi lms are partially crystallized, with crystalline fractions larger than 45% and grain sizes smaller than 50 nm. The B-doping can enhance the crystallization but reduce the grain sizes, and also enhance the preferential growth of Ge (220). The conductivity of thefi lms increases and tends to be saturated with increasingdiborane-to-germane ratio . All the Hall mobilities of the samples are larger than 3.8 cm2·V-1·s-1. A high conductivity of 41.3Ω-1?cm-1 is gained at=6.7%.
其他文献
CuO-doped (Ag0.75Li0.1Na0.1K0.05)NbO3 (ALNKN-xCuO,x = 0-2mol%) lead-free piezoelectric ceramics were prepared by the solid-state reaction method in air atmosphere. The effects of CuO addition on the phase structure, microstructure, and piezoelectric prope
In order to study the size effect on the AE rate ‘a’ value, three kinds of mix ratios were set up by different particle sizes and water cement ratios, 45 cement mortar specimens with ifve different heights were tested under axial compression. And the whol
A novel micro fused-casting for metal (MFCM) process for producing A356 aluminum alloy slurry was proposed. MFCM means that the reifned metal slurry is pressed out from the outlet of bottom of crucible to the horizontal movable plate. With the aid of 3D m
The gas-phase dehydration of glycerol was conducted over HPW/MCM-41 catalysts, which were prepared by impregnation of different amount of H3PW12O40 (HPW) on the MCM-41 support. The samples were characterized by XRD, N2 physisorption, FTIR, NH3-TPD, and py
Ethylene glycol, glycerol, sorbitol, formamide, and urea were used as plasticizers for the preparation of thermoplastic starch (TPS) from corn starch. The properties of TPS were tested by analysis method. The results showed that TPSs were more highly plas
Ferrum niobate was synthesized by solid-phase sintering method in a vacuum carbon tube furnace at 1 300℃ for 180 min. The phase transformation of ferrum niobate carbothermal reduction process was studied by XRD. The reduction reactions of ferrum niobate i
PVC (polyvinyl chloride) was isolated from waste plastic before manufacturing RPF (refuse paper & plastic fuel), and the characteristics of manufactured RPF including properties, calorific value, pyrolysis, chlorine content and kinetics analysis were anal
A series of Cd1-xZnxS/K2La2Ti3O10 composites were synthesized via a simple co-precipitation method. The prepared samples were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), X-ray energy dispersive spectroscopy (EDX), ultravi