Mineralogical and Active Mechanical Excitation Characteristics of Filled Fly Ash Cementitious Materi

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:guozhizhong8017
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
To reveal the influence of mechanical activation on the performance of fly ash,the microanalysis (the energy spectroscopy,XRD and SEM),the distribution size of particle of fly ash and cement paste intensity of various age for different grinding time were studied.The relationships of the activity and the composition of fly ash,microstructure and the distribution of particle size by mechanical activation of fly ash were obtained.The internal glass beads with activity were released by grinding fly ash for a certain time.The particle specific surface area was improved and the hydration reaction of the interface and the surface active center was increased by grinding.The granularity distributing of fly-ash trended towards optimization.The polar molecules or ions were easier to intrude into the internal cavity of the vitreous body.The active silica and alumina of fly ash were rapidly depolymerized.Each performance index of fly ash was increased before grinding for 20 min.Cement paste intensity of various age increased along with the grinding time,and the early strength increase range was big,but the later period intensity increase range hastened slightly.The internal part of vitreous of fly ash was destroyed if the fly ash continued to be ground and the activity of fly ash was reduced.It is suggested that Guozhuang\'s fly ash should be ground for 20 min.
其他文献
To improve the mechanical properties of alumina particulates reinforced steel matrix composite, Ti powder was added into the alumina preform, a 5140 steel matrix composite was fabricated by squeeze casting, and the influences of Ti powder on the microstru
Aiming at the problem of available water conservation in desertification ecological restoration, we prepared the water retention materials with montmorillonite(MMT) modified by Castor Oil Polyoxyethylene Ether(10) (EL-10) emulsifying vegetable waxes. The
We prepared a kind of metal oxide-modified walnut-shell activated carbon (MWAC) by KOH chemical activation method and used for PH3 adsorption removal. Meanwhile, the PH3 adsorption equilibrium was investigated experimentally and fitted by the Toth equatio
An in-situ consolidation method was developed and optimized to successfully fabricate alu-mina ceramics using pre-gelling starch. Our results showed that the obtained ceramics have more homogeneous microstructure, higher density, higher flexural strength,
TiO2 films were coated on the surface of diamond particles using a sol-gel method. The effects of heat treatment temperature on the morphology, phase composition and chemical bond of diamond particles coated with TiO2 films were investigated through SEM,
Three different curing temperatures (20 ℃, 40 ℃, and 60 ℃) were set, so that the non-evaporable water (wn) contents of plain cement pastes cured at these three temperatures were measured to determine the hydration degree of cement. Tests were carried out
The effect of crystallization conditions of poly(butylene succinate) (PBS) component on the crystallization of poly(tetramethylene oxide) (PTMO) component in their segment block copolymer, with a higher PTMO content (PTMO mass fraction is 67%), was invest