论文部分内容阅读
我车间炉前辊道和升降台平衡转轴润滑方式的改革经实践证明,集中润滑是行之有效的。我车间炉前辊道的尾端轴承工作环境温度较高,冲击负荷频繁。在正常的生产过程中又不能向轴承座内加入油脂对轴承进行润滑,仅靠每次检修时用人工注入大量2号MoS_2复合钙基脂,实际上已远远超过了理论上规定的加油量(1/2～1/3空隙量),这样既不利于轴承的润滑,又增加了设备负荷,还浪费了大量润滑脂,长期以来,该设备都因其尾端轴承润滑不
I workshop before the furnace roller table and lift balance shaft lubrication method has been proved by practice, the centralized lubrication is effective. My workshop before the furnace roller end of the bearing temperature higher working environment, the impact load frequently. In the normal production process and can not add grease to the bearing seat to lubricate the bearings, each repair alone with a large number of injection of MoS_2 complex Calcium base fat, in fact, has far exceeded the theoretically required amount of fuel (1/2 ~ 1/3 gap volume), so that is not conducive to bearing lubrication, but also increased the load on the device, but also wasted a lot of grease, for a long time, the device because of its rear bearing lubrication is not