Experimental investigation of supersonic radiation propagation in low-density plastic and copper-dop

来源 :中国科学G辑(英文版) | 被引量 : 0次 | 上传用户:yanglch234
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Eight beams of 0.35 μm laser with pulse duration of 1 ns and total energy of 2 kJ enter into a hohlraum to create intense X-ray radiation of 140 eV on the Shenguang Ⅱ laser facility. Plastic foam (C6H12) and copper-doped foam (C6H12Cu0.394) with a density of 50 mg/cm3 are heated by X-ray radiation emitted from the hohlraum. The breakout time of the radiation wave is measured by a tri-chromatic streaked X-ray spectrometer (TCS) that consists of a set of three imaging pinholes and an array of three transmission gratings coupled with an X-ray streak camera (XSC). At one shot, the simultaneous measurements of the delay of the drive source and the radiation transport at two energies (210 eV, 840 eV) through the foam have been made for the first time. The experimental results indicate that the time delays vary with photon energies. With a transmission grating spectrometer (TGS), the spectra transmitting foams were measured, and the lower limit of the optical depth was measured. The radiation at energy of 210 eV propagates through plastic foam at a faster velocity, compared with the radiation at energy of 840 eV; while the results of copper-doped foam are reverse. The optical depth in the plastic foam is less than 1, and in the doped foam it is more than 1.
其他文献
Based on analyzing the thermal process of a CDQ (coke dry quenching)-Boiler system, the mathematical model for opti- mized operation and control in the CDQ-Boil
The piperonal electron affinity was studied using pulse radiolysis technique. The electron transfer reaction process between piperonal and anthraquinone-2-sulfa
The design, fabrication and characterization of the X-ray supermirrors are discussed in this paper. Using the local optimization method of simplex algorithm and
The present work proposes kinetics of ionization-recombination to study the charge state distribution of Au plasma. The first step is to calculate the average l
Highly pure active γ-Al2O3 nanoparticles were synthesized from aluminum nitrate and ammonium carbonate with a little surfactant by chemical precipitation metho
Many aspects of the behavior of surfactants have not been well understood due to the coupling of many different mechanisms. Computer simulation is, therefore, a
The measurements of temperature and moisture content of a wet porous material were accomplished on the micro-seconds scale. The temperature wave was observed wh
The feasibility of the fabrication of coatings for elevated-temperature structural applications by laser cladding MoSi2 pow- der on steel was investigated. A de