论文部分内容阅读
地质剖面图目前已为人们所习见,编制这种图件一般须经过两个步骤,首先是根据剖面线与岩层走向的交角换算出地质剖面中岩层的倾角;但当剖面的纵横比例尺不一致时,就得考虑第二步,利用比例尺的不一致,把原有剖面中应有角度予以换算。经过这祥的两个步骤,才能将图编制正确,也才能使地质剖面图在设计图表中发挥应有的作用。一般说来,在编制地质剖面图的过程中,第一个步骤已为同志们所熟悉,也有比较完整的换算表格,可以编制出正确的剖面图。但当比例尺不一致时,就必须进行第二个步骤,而这一步工作常为同
Geological profile is now known to people, the preparation of this map is generally required to go through two steps, first of all, according to the cross-section and the direction of the strike of the formation of the conversion of the geologic profile of the slope; but when the profile aspect ratio is inconsistent, You have to consider the second step, the use of scale inconsistencies, the original profile should be the angle to be converted. After this auspicious two steps in order to map the correct, but also to make the geological profile in the design chart to play its due role. In general, the first step in the process of compiling a geological profile is already familiar to the comrades and there is also a more complete conversion table in which the correct profile can be prepared. However, when the scales are not consistent, the second step must be carried out, and this step is often the same