圆管杆件与板的斜接焊缝,一般是将圆管端部开一直槽,在槽中插入连接板1,再由连接板1和平板2相连,装配后进行定位焊,然后再施焊。但为了安装方便,也有改用现场安装施焊的(图1)。连接时,只要两边焊缝分布 Pipe rod and plate slant seam, the pipe is usually open a straight slot at the end, inserted in the slot connecting plate 1, and then by the connecting plate 1 and 2 connected to the plate, the positioning after the assembly welding, and then re-Shi weld. However, in order to facilitate the installation, but also use the site installation welding (Figure 1). When connecting, as long as both sides of the weld distribution