轧制过程和轧机的研究在50.8毫米摆式轧机上的最初试验,是为了证明这种轧制方法的实用性。在研究的最初阶段,曾以不同的轧制速度和送料速度轧制原始厚度和成品厚度不同的铝和 HE30铝合金。一些试轧结果列于表1中。最初,由于条件困难,坯料加热是在附近的炉子中进行。经过改进后,在送料辊和工作辊之间 Rolling Process and Mill Research The initial test on a 50.8 mm tilting mill was to demonstrate the practicality of this rolling method. In the initial stages of the study, aluminum and HE30 aluminum alloys of different initial thicknesses and finished thicknesses were rolled at different rolling speeds and feed rates. Some of the results of the trials are listed in Table 1. Initially, due to difficult conditions, the billet was heated in a nearby furnace. After the improvement, between the feed roller and the work roll