槲皮素对牙本质抗酸蚀性能的影响

来源 :中华口腔医学杂志 | 被引量 : 0次 | 上传用户:ujjih
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
目的 评价槲皮素对人牙本质抗酸蚀性能的影响,为探寻理想的牙侵蚀症预防和治疗方案提供依据.方法 选择福建医科大学附属口腔医院口腔颌面外科门诊提供的因正畸需要而拔除的人第三磨牙50颗,制备牙本质试件128个,用随机数字表法将试件随机分为8组(每组16个).各组(每组选12个试件)分别用去离子水(对照组)、无水乙醇(对照组)、12.300 mg/L氟化钠、0.120 mg/L氯己定、0.183 mg/L表没食子儿茶素没食子酸脂(epigallocatechin gallate,EGCG)和0.075、0.150、0.300 mg/L槲皮素进行处理.每天37℃下用各组相应试剂浸泡试件2 min、去离子水冲洗并静置于人工唾液2h后,使用柠檬酸(pH=2.45)进行4次酸蚀循环;连续7d.分别检测试件酸蚀前后的表面显微硬度及表面轮廓(计算表面硬组织丧失量),用扫描电镜观察试件表面形貌.各组剩余4个试件用10%磷酸脱矿后干燥过夜,37℃下用各组相应试剂浸泡2 min,置于人工唾液中浸提7d,检测浸提液中Ⅰ型胶原吡啶交联终肽(cross-linked carboxyterminal telopeptide of type Ⅰ collagen,ICTP)含量.结果 相比对照组,氯己定、槲皮素、EGCG均可显著抑制酸蚀循环引起的牙本质表面软化和硬组织丧失,0.300 mg/L槲皮素组试件酸蚀后表面显微硬度减小率最小[(8.75±4.95)%],表面硬组织丧失量最小[(2.26±1.16)μm],ICTP含量最低[(5.72±0.88) ng],均显著低于氯己定及EGCG组(P<0.05).各槲皮素组表面硬组织丧失量和ICTP含量差异均无统计学意义(P>0.05);0.300 mg/L槲皮素组酸蚀后表面显微硬度减小率均显著小于0.075和0.150 mg/L槲皮素组(P<0.05).结论 槲皮素可显著提高人牙本质抗酸蚀性能,其中0.300 mg/L槲皮素的作用最佳.“,”Objective To evaluate the effects of quercetin on dentin resistance to erosion and provide evidence-based recommendations for the prevention and therapy of dental erosion.Methods One hundred and twenty-eight dentin samples were prepared from 50 extracted human wisdom teeth (collected from Department of Oral Surgery,School and Hospital of Stomatology).Ninety-six samples were randomly divided into 8 groups using the following different soaking solutions:deionized water,ethanol (control groups),12.300 mg / L sodium fluoride,0.120 mg / L chlorhexidine,0.183 mg / L epigallocatechin gallate (EGCG),and 0.075,0.150 and 0.300 mg/L quercetin.In each group,twelve specimen was prepared.Before daily acid challenge,the samples were immersed in the respective solutions for 2 min,rinsed with deionized water,and immersed in artificial saliva for 2 h.The samples were then subjected to 4 cycles of in vitro acid challenges.This protocol was applied for 7 d.The surface microhardness (SMH) and surface profiles were measured before and after erosion using the surface microhardness tester and contact profilometry,respectively.The change in surface profiles and reduction in SMH were used to calculate the substance loss and reduction percentage of SMH (SMH%) respectively.Scanning electron microscope (SEM) images were taken to observe the surface morphology of the samples.Additionally,another thirty two samples were divided into 8 groups (n=4) as mentioned above.The specimens were treated with 10% phosphoric acid and desiccated,immersed in the respective solutions for 2 min,rinsed,and immersed in the artificial saliva at 37 ℃ for 7 d.The content of cross-linked carboxyterminal telopeptide of type Ⅰ collagen (ICTP) in the soaking solutions were measure quantitatively.Results Compared with the control groups,the applicationof chlorhexidine,quercetin,and EGCG were effective in preventing the surface softening and substance loss of human dentin after erosion.More specifically,the specimens treated with 0.300 mg/L quercetin exhibited the lowest SMH% [(8.75±4.95)%],the lowest surface substance loss [(2.26± 1.16) μm],and the lowest contents of ICTP in the soaking solution [(5.72 ± 0.88) ng],showing significant differences to the chlorhexidine and EGCG treated samples (P<0.05).No significant differences were found in the substance loss and ICTP contents in the three soaking solutions with different concentrations of quercetin(P > 0.05).However,the specimens treated with 0.300 mg/L quercetin exhibited significantly lower SMH% than those treated with the other two concentrations of quercetin (P<0.05).Conclusions Within the limitations of the current study,immersion in the quercetin solution is effective in improving the dentin resistance to erosion by inhibiting the dentinal MMP.Among all the concentrations tested,0.300 mg/L quercetin showed the best performance.
其他文献
采用Fluent软件中的ED燃爆模型对空气-乙烷多元混合体系进行二维稳态燃爆模拟.结果 表明,5种工况球中心燃爆最高温度瞬间可分别达到900 K、1 000 K、1 100K、1 150K和1 200 K
在严重的环境污染和严峻的能源紧缺形势下,节能减排是汽车行业永恒的发展主题。燃油雾化作为内燃机燃烧的关键环节,直接影响了发动机的动力性、经济性、排放性及寿命。改善燃
涡轮增压能够大幅度提高内燃机的性能,减少汽车有害排放量,已经成为柴油机、汽油机的高性能配套装置。而涡轮是涡轮发动机的主要热端部件,由于发动机排放气体温度很高,通常在
基于IHP 130 nm SiGe BiCMOS工艺,设计了一种中心频率为140 GHz的三级Cascode结构的功率放大器.该放大器由两个驱动级和一个输出功率级组成,输入、输出和级间匹配均采用微带
缸内直喷汽油机(GDI)在动力性和燃油经济性方面具备进一步挖掘的潜力,是内燃机发展的重要方向之一。GDI发动机的关键点及难点在于在燃烧室内形成理想的稀燃混合气,其中喷油压
设计实现了一种可用于脊髓神经刺激器的多通道大电流神经刺激器.提出将电极短接和插入短电流脉冲相结合的混合模式,在大电流下,能更加快速地实现电荷平衡.电路设计上,将ADC动
二氧化碳浓度急剧升高引发的全球气候变暖已成为当今时代的最大挑战,二氧化碳排放主要来自于人类化石燃料燃烧。捕集化石燃料燃烧产生的CO2,并对其进行隔离和封存是当前解决CO2
设计了一种采用通道复用技术的低功耗心电信号采集电路.该电路由多通路数据选择电路、前置放大器、缓冲器和Gm-C低通滤波器组成.多通路数据选择电路中的开关采用栅压自举型开