论文部分内容阅读
一、变速器第二轴上止推环磨损变薄后处理方法东风EQ!40-1型汽车修理技术标准规定,第二轴二档齿轮端隙为0.05~0.37,四档齿轮端隙为0,10~035,当第二轴上四档齿轮及二档齿轮后止推环磨损变薄后,间晾超过技术标准时,会使齿轮产生轴向窜动,改变齿轮的啮合长度,并产生轴向力,会导致跳档。维修中止推环磨损后可更换,无新件时可在止推环下加薄垫,(如用健力宝盒剪出薄垫),注意垫子应加在轴上靠台肩的一面。二、发动机“开锅”后处理在汽车行驶或发动机试验中,如出现发动机“开锅”及冷却水不足时,
First, the transmission shaft thrust ring wear thinning post-processing methods Dongfeng EQ! 40-1-type automotive repair technical standards, the second shaft gear gear clearance of 0.05 to 0.37, fourth gear end clearance of 0, 10 ~ 035, when the fourth gear on the second shaft and second gear after the thrust ring wear thinning, drying more than the technical standards, will make gears produce axial play, change gear meshing length, and produce axial Force, will lead to jump files. Repair ring can be worn after wear replacement, no new pieces can be added under the thrust ring thin pad, (such as using Jianlibao box cut thin pad), note pad should be added on the shaft side by shoulder. Second, the engine “boil ” post-processing In the car running or engine test, such as the engine “open pot ” and the cooling water is insufficient,