Influences of Cement Temperature on the Performance of Concrete

来源 :The 14th International Congress on the Chemistry of Cement ( | 被引量 : 0次 | 上传用户:QINSHAOKUN1988
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  In order to investigate the influence of temperature of low heat Portland cement on the performance of concrete mixed with polycaboxylate superplasticizer, this paper selected two kinds of polycaboxylate superplasticizers,and explored the effect of low heat Portland cement temperature changes on the mixes properties and early age mechanical properties of concrete.The results showed that 1) temperature of low heat Portland cement has greater impact on the workability of concrete, when the cement temperature was higher than 60℃, the concrete occurred slight bleeding phenomenon;2) the setting times of concrete and cement temperature were following inverse relationship;3) the slump loss rate and air content loss rate of concrete was proportional to cement temperature, the higher cement temperature, and the greater loss rate with time;4) the early ages compressive strength of concrete were increasing with the changing of cement temperature, the same ages compressive strength was greatly impacted by the changing of cement temperature;5) since the quality performance of polycaboxylate superplasticizers were different, the sensitivity of two kinds of superplasticizers to cement temperature changes were different too.
其他文献
Compared with the added gypsum, protogenetic anhydrite is those anhydrite in clinker and admixture.And using protogenetic anhydrite as setting retarder instead of added gypsum to make cement could be
This paper presents results from the analysis of the first 48 hours of the hydration of three high-volume blended BFS-PC systems.This work has been carried out on the I11 beamline of the Diamond Light
Cementitious material is one of the potential substrates for widely practical application of photocatalysis.The loading effect and photocatalytic performance were investigated by loading nano-TiO2 on
A recently-developed technique for studying time-dependent properties of cement-based materials is presented.It is based on the replacement of a certain volume of cement/binder grains that would remai
Industrial use of waste carbon dioxide gas as an upcycled feedstock into concrete has realized strength benefits when applied to masonry blocks and ready mixed concrete.The introduction of carbon diox
Tricalcium silicate is the main component of cement, and the key phase during OPC hydration.Therefore, a detailed control over its reactivity could entail important technological and economical advanc
Belite-rich cements with enhanced reactivity have been long pursued, due to the benefits of the low sintering temperature and CaCO3 demand compared with alite-rich cements.In this work, the physi-and
In the manufacture of ordinary Portland cement, the clinker is inter-ground with mineral gypsum which provides sulphate ions to regulate hydration of calcium aluminate (C3A) phase resulting in retarda
Hydration of slag-cement cementitious material was studied through the use of a mode TAM Air eight-channel isothermal conductive calorimeter that measured the hydration heat emission rate and quantity
Rapid water-loss is one of the important characters on thin layer mortar.The testing methods, such as the velocity of water migration, the strength of interfacial bonding, XRD, SEM, FTIR and TD-DSC-DT