Calculation of plasma properties of a carbon-hydrogen mixture

来源 :13th Asia-Pacific Conference on Plasma Science and Technolog | 被引量 : 0次 | 上传用户:weiyideta21
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  Calculated values of equilibrium composition,thermodynamic and transport properties of a mixture of 50% carbon and 50% hydrogen are presented in this paper.The calculations are performed under atmospheric pressure and in the temperature range of 300 K-30000 K,which assume local thermodynamic equilibrium.Thermodynamic properties are calculated by theoretical analysis of statistical thermodynamics.Calculations of transport properties,including viscosity,thermal conductivity and electrical conductivity,are carried out using the Chapman-Enskog method up to higher approximations.A complete database of transport cross sections for relevant interactions has been derived from interactive potentials[1]or calculated using analytical forms reported in previously published studies.
其他文献
To investigate the influence of plasma actuator dispose position and control parameters on aircraft lift enhancement,wind tunnel experiment was taken on flying wing aircraft.AC and nanosecond pluse pl
We clarify the coupling relationship and competition between the QED effect and the plasma collective effect and find the critical condition that makes the birefringence vanish.In a relative weak elec
In this study,soil polluted with pyrene was remediated using a dielectric barrier discharge (DBD) plasma reactor at atmospheric pressure.Influencing factors,including treatment time,discharge voltage,
In the last decades,plasma used in aerospace industry has attracted more and more attention for its high efficiency and fast reactivity.Meanwhile,the gas flow can greatly influence the discharge chara
Electrical properties of Ar-N2 inductively coupled thermal plasmas were investigated according to the N2 content by using a numerical model for the computation of magneto-hydrodynamic flow and equival
In the technology of etch process,it demands a deep trench with high aspect ratio.And it is widely known that ion flux and energy can be independently controlled by using high and low frequency[1].
The remediation of NOx emission from diesel exhaust or gas turbines has been widely studied for atmospheric pollution and human health.[1]In order to reduce exhaust gases,non-thermal atmospheric plasm
In an open air,atmospheric pressure plasma jets operate to apply numerous applications including surface modifications,environmental issues,and bio medicine.Both in research and commercial areas,mostl
B4C/Cu functionally gradient material (FGM) is a promising candidate for plasma facing material (PFM) in fusion device,because it can mitigate the thermal stress caused by the mismatch of the coeffici
Thermal plasma has the characteristic such as high temperature,high enthalpy and high energy density.It can make any particles melting and then the melted particle formatting into spherical particles