【摘 要】
：
CuO-ZnO-Al2O3 is a typical catalyst for methanol synthesis from CO2 hydrogenation.CuO-ZnO-Al2O3 was modified with SiO2 which was hydrolyzed from tetraethyl orthosilicate (TEOS), using co-precipitition
【机 构】
：
Department of Catalysis Chemistry and Engineering, School of Chemical Engineering, Dalian University
【出 处】
：
The 6th Joint China-Japan Chemical Engineering Symposium(第六届
论文部分内容阅读
CuO-ZnO-Al2O3 is a typical catalyst for methanol synthesis from CO2 hydrogenation.CuO-ZnO-Al2O3 was modified with SiO2 which was hydrolyzed from tetraethyl orthosilicate (TEOS), using co-precipitition method.The promoted catalysts were tested under the conditions of 200 ℃, 2.4 Mpa, H2∶CO2=3∶1 (volume ratio), SV=3600 h-1.Results show that the promoted samples are better than the CuO-ZnO-Al2O3, and 2 wt.% is the optimal dosage with CO2 cony.improvement by 48.68% and CH3OH yield by 39.86%, respectively.XRD, CO2-TPD, H2-TPD, H2-TPR and FT-IR characterizations were performed, and results showed SiO2 improved the CuO dispersion in the catalyst, enhancing the adsorption/activation of CO2 and H2 on the catalyst, and promoting the intermediate species such as formates and carbonates, made the active component CuO be reduced more easily.
其他文献
Diphenyl carbonate (DPC) is a material for the green production of Polycarbonate.Among of non-phosgene methods for the synthesis of DPC, the transesterification between dimethyl carbonate (DMC) and ph
The interaction between antibacterial olaquindox (OLA) and bovine serum albumin (BSA) was studied by fluorescence spectroscopy and UV-vis absorption spectroscopy.Spectroscopic analysis of the emission
Torrefaction can be defined as a biomass pretreatment stage via heating at a moderate temperature between 473 and 573 K in inert condition to produce higher energy density, longer shelf life, better g
Methane steam reforming is a high endothermic reaction for production of hydrogen.In order to improve heat supply to the reforming zone, using structured catalysts, the methane-steam reforming system
Dimethyl carbonate (DMC) is an attractive chemical with versatile applications, which is required an increasing production capacity.Copper (Ⅰ and Ⅱ) chlorides are known as effective catalysts to produ
The perovskite metal oxide support and the corresponding palladium supported catalyst were prepared by microwave roasting method and conventional method.Both of the catalysts were used in the synthesi
In this paper, 2-monoethyl succinyl-9,9-bis(methoxymethyl)fluorene was synthesized successfully involving etherification, esterification and Frieded-Crafts acylation, which fluorene etc.were used as p
Polyethylene is one of the most widely used polymers in industry as fiber, film and bottle because it has many advantageous properties such as easy of processing, high chemical resistance, flexibility